Antara Owners Club banner
1 - 4 of 4 Posts

·
Registered
Joined
·
104 Posts
Discussion Starter · #1 ·
You can reset your own service light after an oil change by the procedure below.

The reset procedure

1. Close all the vehicle doors

2. Press the accelerator pedaldown. Switch on ignition, (Fully press accelarator pedal up and down 3 times within 5 seconds),

3. Switch off ignition.
Only do this reset after an oil change is it resets the counter for DPF forced regenerations. If you do this without changing the oil, you risk getting the oil too diluted with diesel and can damaging the engine.
 

·
Registered
Joined
·
8 Posts
I've just been looking at the oil extractor devices that suck the oil out through your dipstick instead of underneath. Is this what you use? Looks a lot easier than undoing stuff underneath! Lol
 
1 - 4 of 4 Posts
Top