Hi folks,
I posted recently after buying an Antara and a couple of warning lights came up after driving for a bit:
the vehicle with a spanner and the engine with a down arrow came on briefly a few times. There was no change in the performance of the car.
I got a new obd app and plugged it in tonight.
Came back with these faults:
P0101 [0x0101]
Mass air flow (MAF) sensor/volume air flow (VAF) sensor - range/performance problem
P0673 [0x0673]
Glow plug, cylinder 3 - circuit malfunction
P0674 [0x0674]
Glow plug, cylinder 4 - circuit malfunction
B2924 [0xA924]
General Electrical Failures [0x00]
B1516 [0x9516]
Battery Current Sensor Signal
I cleared the codes, started the engine, switched it off and read for any codes again.
This is what came back:
P0673 [0x0673]
Glow plug, cylinder 3 - circuit malfunction
P0674 [0x0674]
Glow plug, cylinder 4 - circuit malfunction
B2924 [0xA924]
General Electrical Failures [0x00]
So looks like I'm going to need new glow plugs I take it? Are they expensive at all?
I noticed the MAF didn't come back after the first codes were cleared, but wonder if that's because I didn't drive the car before the second test... If it comes back after a drive, what's the story with that?
Thanks in advance folks.
I have 3 months warranty with the car, so hopefully it will cover any of this work...
I posted recently after buying an Antara and a couple of warning lights came up after driving for a bit:
the vehicle with a spanner and the engine with a down arrow came on briefly a few times. There was no change in the performance of the car.
I got a new obd app and plugged it in tonight.
Came back with these faults:
P0101 [0x0101]
Mass air flow (MAF) sensor/volume air flow (VAF) sensor - range/performance problem
P0673 [0x0673]
Glow plug, cylinder 3 - circuit malfunction
P0674 [0x0674]
Glow plug, cylinder 4 - circuit malfunction
B2924 [0xA924]
General Electrical Failures [0x00]
B1516 [0x9516]
Battery Current Sensor Signal
I cleared the codes, started the engine, switched it off and read for any codes again.
This is what came back:
P0673 [0x0673]
Glow plug, cylinder 3 - circuit malfunction
P0674 [0x0674]
Glow plug, cylinder 4 - circuit malfunction
B2924 [0xA924]
General Electrical Failures [0x00]
So looks like I'm going to need new glow plugs I take it? Are they expensive at all?
I noticed the MAF didn't come back after the first codes were cleared, but wonder if that's because I didn't drive the car before the second test... If it comes back after a drive, what's the story with that?
Thanks in advance folks.
I have 3 months warranty with the car, so hopefully it will cover any of this work...
